Safety button will not move to select over barrel
4 posts
• Page 1 of 1
I recently purchased a 1st generation Winchester 101 made in Japan (serial no. 55XXX. The safety button will not move to the left in the off position to select the over barrel. Were some of the earlier models made this way? If so, can I do something so I will be able to select barrels? How do you remove the safety button? Thanks.
|
|
Welcome to the site.
I am not familiar with Japan Winchesters. Check with Winchester for guidance. Could be a recall. GOA Life Member
NRA Sustaining Member USMC Korea vet Retired CWO3 USCGR |
|
Found out that there was a selective safety filler block installed which prevented barrel selection. I removed the safety button by turning the safety spring 90 degrees to disengage the spring from the safety and lifting the safety button out. The filler block can then be removed from the safety button. Reinstalled the safety button and spring and now barrel can be selected as needed.
|
|
Nice work. Good there is no safety recall. Black the barrel change safety. Hummmm!
GOA Life Member
NRA Sustaining Member USMC Korea vet Retired CWO3 USCGR |
|
4 posts
• Page 1 of 1
Return to Winchester Model 101
Who is online
Users browsing this forum: No registered users and 1 guest
Winchester Owners Forum is privately owned and operated. It is not affiliated or operated by Winchester company.
Views and opinions expressed here are not necessarily that of Winchester.