1942 Winchester Model 94 Butt Plate
3 posts
• Page 1 of 1
Just bought a 1942 Winchester Model 94 in NRA Good condition. The One big problem I have is the Butt Plate was replaced many years ago with a rubber recoil pad. I want to get it back to original condition with the proper butt plate. I need one 4 5/8 inches long by 1 1/2 inches wide and 3 1/2 inches between screws. My wood stock is flat so the butt plate must be flat. I have searched everywhere I can think of. Anyone have any ideas? The rear stock seems to be the right size so I don't think it was cut. Any experts out there? Thanks!
|
|
Try Numrich Gun Parts yet...!?
|
|
I just acquired an early 40's 94. It has a flat metal but plate with horizontal serrations between the screws.
|
|
3 posts
• Page 1 of 1
Return to Winchester Model 1894
Who is online
Users browsing this forum: No registered users and 5 guests
Winchester Owners Forum is privately owned and operated. It is not affiliated or operated by Winchester company.
Views and opinions expressed here are not necessarily that of Winchester.