Page 1 of 1
Screw hole fill
Posted:
Sat May 19, 2018 11:43 am
by Dconnell
Does anyone know the approximate cost to fill in screw holes from previous scope mounts? I have a '68 model 94 that has multiple holes.
I would like them to be welded (TIG?) permanently.
Any recommendations on anyone that does thIs work? This is by no means a collector gun. I just want the holes filled.
Thanks
Re: Screw hole fill
Posted:
Sun May 20, 2018 7:19 pm
by sschefer
You would want a gunsmith to do this for you. I would expect to pay an hourly rate since welding is typically charged by the inch which wouldn't be practical in this case.
In thinking about it, I would probably use a suitable screw to fill the hole instead of welding. You could take it one step further by removing the screw head and blending it in. I think it might be less noticeable in the end.
Re: Screw hole fill
Posted:
Mon May 21, 2018 8:23 am
by XLIV
Ditto, take it to a gun shop ask them to install filler screws with locktite ane file the screw slots flush. A little cold blue touch up and it wont cost arm and leg
44
Re: Screw hole fill
Posted:
Sun Jul 15, 2018 6:41 pm
by bob lewis
Dennis Olsen in Plains, Montana did some on my pre-war M 70. There were 5 holes, one of which was in the "r" in Winchester can't see the welds and the "r" is complete! This was done in conjunction with metal work to and bluing the the Montana barrel cost was about $ 500 for all several years ago