Does anyone know the approximate cost to fill in screw holes from previous scope mounts? I have a '68 model 94 that has multiple holes.
I would like them to be welded (TIG?) permanently.
Any recommendations on anyone that does thIs work? This is by no means a collector gun. I just want the holes filled.
Thanks
Screw hole fill
4 posts
• Page 1 of 1
You would want a gunsmith to do this for you. I would expect to pay an hourly rate since welding is typically charged by the inch which wouldn't be practical in this case.
In thinking about it, I would probably use a suitable screw to fill the hole instead of welding. You could take it one step further by removing the screw head and blending it in. I think it might be less noticeable in the end. |
|
Ditto, take it to a gun shop ask them to install filler screws with locktite ane file the screw slots flush. A little cold blue touch up and it wont cost arm and leg
44 |
|
![]() .270 WIN
Posts: 184
Joined: Fri Jul 11, 2014 7:56 pm Location: Northern California |
Dennis Olsen in Plains, Montana did some on my pre-war M 70. There were 5 holes, one of which was in the "r" in Winchester can't see the welds and the "r" is complete! This was done in conjunction with metal work to and bluing the the Montana barrel cost was about $ 500 for all several years ago
Too old to be nice, never too old to learn!
|
4 posts
• Page 1 of 1
Return to Winchester Model 1894
Who is online
Users browsing this forum: No registered users and 18 guests
Winchester Owners Forum is privately owned and operated. It is not affiliated or operated by Winchester company.
Views and opinions expressed here are not necessarily that of Winchester.