WinchesterOwners.com

I need identifying the screws i need for this 94 i just picked up. Looks like it may have been a commemorative, but there is no medalion in the stock. Please see 3 photos. One looks like it would go where a saddle ring would go.
I have 3 holes I need to fill and Numrich did not seem to have the anwers for me in their hard to read schematic. thanks for any help. Serial # dates it at 1968

Right Side - hole just above the loading gate


Left Side - hole where it looks like a saddle ring might go



Left Side - towards front in middle of pic - looks like a pin may be in there but still leaves a hole.

It looks lika an 'Antique' Commemorative. I had one briefly. I will be going downstairs shortly and will check the safe and compare it tomy 94s.

Welcome to the Winchester Owners Forum Rogmatt !!

Let us know how you make out with those missing receiver screws...

The hole on the right side is for pushing out the lever link pin upon disassembly and does not get a screw. The saddle ring hole will either take a new saddle ring or a 8-40 plug. I think the other pin is holding internal parts in. So to make a long story short. You only need one for the saddle ring hole