Checkering Specs needed.


Copper BB
Posts: 4
Joined: Mon Oct 17, 2016 2:40 pm
PostPosted: Wed Aug 07, 2019 6:49 pm
I am having a new stock made for a Winchester Model 52 Sporter.

Original stock was damaged and a previous owner had attempted sanding off the fore grip checkering panels and had them put back by someone who would have to have been 10 times better than this work to be considered a lame amateur.

Can't tell if the placement of the panel is in the correct place or not or if the dimensions are correct. They messed with the 3 diamonds on the bottom also so their exact placement and size cannot be determined.

Is there any where out there or does anyone have a document showing the spacing and sizing specifications for the checkering patterns on the Sporter rifle.

Pics below show the measurements I need.


Image

Image

Image

Thanks in advance for any and all help.
User avatar
20g
Posts: 916
Joined: Sun May 25, 2014 5:06 pm
Location: Central Louisiana
PostPosted: Thu Aug 08, 2019 9:18 pm
Hi ya rjtmac, forum is not very active. Do you think a call to Winchester would help?
GOA Life Member
NRA Sustaining Member
USMC Korea vet
Retired CWO3 USCGR

Return to Pre-64 Models

Who is online

Users browsing this forum: No registered users and 9 guests

Winchester Owners Forum is privately owned and operated. It is not affiliated or operated by Winchester company. Views and opinions expressed here are not necessarily that of Winchester.