1942 Winchester Model 94 Butt Plate
3 posts
• Page 1 of 1
Just bought a 1942 Winchester Model 94 in NRA Good condition. The One big problem I have is the Butt Plate was replaced many years ago with a rubber recoil pad. I want to get it back to original condition with the proper butt plate. I need one 4 5/8 inches long by 1 1/2 inches wide and 3 1/2 inches between screws. My wood stock is flat so the butt plate must be flat. I have searched everywhere I can think of. Anyone have any ideas? The rear stock seems to be the right size so I don't think it was cut. Any experts out there? Thanks!
|
|
Try Numrich Gun Parts yet...!?
|
|
I just acquired an early 40's 94. It has a flat metal but plate with horizontal serrations between the screws.
|
|
3 posts
• Page 1 of 1
Return to Winchester Model 1894
Who is online
Users browsing this forum: No registered users and 12 guests
Winchester Owners Forum is privately owned and operated. It is not affiliated or operated by Winchester company.
Views and opinions expressed here are not necessarily that of Winchester.