Hey everyone I am new to this forum.
I just purchased a new large loop lever for my Winchester 9422, but I can't find any instructions on how to remove the lever and replace it with the large loop. It looks like it's just a pin in, pin out. Am anyone clarify this for me and any other instructions a first timer would want to know before attempting this procedure.
Thanks
Chris

Do not know but it could be as simple as pin out and pin in, however I am sure there is a certain procedure to do so. Sorry I can not help as I do not know, but i'd be willing to bet it isn't hard but more than a pin out and pin in.

Cold War grunt,
Thanks, I was hoping someone would have an assembly manual for the Win 9422. Or at least done this to theirs.

Where did you get you're large lever?

Got Lucky and Picked it up from eBay. I was serchig for it for years. They came up once or twice but the price was outrageous. I just waited till I was willing to pay. Wound up winning the auction for $176 and I was happy. I’ve seen them sold for over $250, both other times. Funny thing is, I have been looking for a 16 inch Trapper Barrel as well, after about another year, I finally found one and won it for $111 and it was the same guy. He must have a ton of stuff cause he outfitted me with the 16”brass plunger and the 16” Mag tube for another $25. Now I need to figure out how to swap them out.

thank you for the info. eBay is a great place for gun parts. Now I will keep my feelers out for a big loop

I’ll shoot him an email and see if he has anymore large loop levers, if he does I’ll give you his contact info.

Thanks, but it may be a little while. Like after the first of the year. just spent a load on a 1955 Mountie and a 1978 9422