 Posted: Fri Nov 09, 2012 10:45 pm
I need identifying the screws i need for this 94 i just picked up. Looks like it may have been a commemorative, but there is no medalion in the stock. Please see 3 photos. One looks like it would go where a saddle ring would go.
I have 3 holes I need to fill and Numrich did not seem to have the anwers for me in their hard to read schematic. thanks for any help. Serial # dates it at 1968 Right Side - hole just above the loading gate  Left Side - hole where it looks like a saddle ring might go  Left Side - towards front in middle of pic - looks like a pin may be in there but still leaves a hole. 
|
|
.22LR
Posts: 15
Joined: Thu Nov 08, 2012 5:03 am Location: Bathurst, NSW Australia |
Posted: Sat Nov 10, 2012 10:37 pm
It looks lika an 'Antique' Commemorative. I had one briefly. I will be going downstairs shortly and will check the safe and compare it tomy 94s.
"I'll helpyou down the trail and proud to!" Rooster Cogburn.
Towns tamed, widders consoled, deep thoughts thunk, sipping whisky graded. |
|
Posted: Thu Nov 15, 2012 1:43 pm
Welcome to the Winchester Owners Forum Rogmatt !!
Let us know how you make out with those missing receiver screws... |
|
|
Posted: Sun Mar 03, 2013 10:47 pm
The hole on the right side is for pushing out the lever link pin upon disassembly and does not get a screw. The saddle ring hole will either take a new saddle ring or a 8-40 plug. I think the other pin is holding internal parts in. So to make a long story short. You only need one for the saddle ring hole
|
|
Return to Winchester Model 1894
Users browsing this forum: No registered users and 72 guests
The team
Delete all board cookies• All times are UTC - 5 hours 
Rogmatt's Profile